Tusk Fitting Instructions


Fitting Instructions

You need: a mug, a fork, a towel a mirror and some water in a cauldron or kettle

  1. Boil water and pour into a mug
  2. Place ONE tusk into the mug and wait for the root to turn fully clear
  3. Remove tusk using a fork and dry it off. Wait a few seconds and let it cool, just like your orcsona its hot!
  4. Place the tusk over or near your lower canine (look for L and R on the part that faces into the mouth to make sure you have the correct side)
  5. Make sure your tooth is in or near the depression on the bottom of the tusk root
  6. Press the tusk root down on the tooth while pushing it towards the back of your mouth
  7. Relax your jaw and gently close your mouth pressing your upper tooth into the root pad on the top of the tusk (DO NOT BITE DOWN)
  8. Use your fingers to flatten any extruded root material in front and then open your mouth and do the same in the back (try not to wiggle the tusk)
  9. Close your mouth and create suction for 2 minutes
  10. Repeat with other tusk
  11. Remember NEVER eat, drink, bite or sleep while wearing your Chompers

TIP: Hold Chompers under warm water before each use to slightly soften the root material. 

Troubleshooting: If you have a loose fit: place the tusk back in the boiling water, reform the root with your fingers and try again. It can take a few attempts to find the right spot. If you have issues with a loose fit You may need a few additional beads of tusk root material (included in the small jar) for a tight lock.